This dialog allows you to configure the microHAM micro BAND DECODER.
For details on the operation of the micro BAND DECODER please visit their web site or consult your user manual.
The Band Decoder Configuration Dialog is activated from the MacLoggerDX File menu.
When activated the dialog will attempt to read the configuration data from the micro Band Decoder that is attached to the Radio serial port specified in the MacLoggerDX Preferences Panel.
If successful, the configuration data will set the controls in the dialog accordingly and you can modify those paramters with the configuration dialog controls. When you press "OK" the modified configuration data will be sent to the micro Band Decoder.
The "Reload" button will reload the configuration data from the micro Band Decoder into the configuration dialog controls.
The "Save" button will the modified configuration data will be sent to the micro Band Decoder (the same as when you press OK).
The "Defaults" button will load band boundary and split data into the configuration dialog - you will have to press "Save" to send the data to the micro Band Decoder.
The "Load Firmware" button will prompt you to select a micro band Decoder Firmware File to upgrade the micro Band Decoder with. If you choose this option do not power down the computer or micro Band Decoder while the firmware is loading or you may put your micro Band Decoder in an unuseable state.
The "Cancel" button dismisses the configuration dialog without affecting the micro Band Decoder.